How to hard reset TP-Link wireless access points, extenders to factory defaults

User Application Requirement
Updated 04-18-2019 00:32:41 AM 1110583
This Article Applies to: 
Note: A hard reset will restore your device to factory default settings. You should reconfigure the device from scratch or you can load the configuration file you have backed up before the reset.
 
To perform a hard reset please follow the instructions below. Method 1 is applicable for most of the models. For models which can be hard reset by using Method 2 please refer to appendix.
 
Method 1:
Directly press and hold the reset button on the rear panel with a solid pin for approximately 8 to 10 seconds when the device is powered on.  If you can see all the lights flashing, then go off and  some lights go back on slowly, that means the device has been reset successfully.
 
Method 2:
Directly press and hold the reset button on the rear panel with a solid pin for approximately 1 to 2 seconds when the device is powered on. If you can see all the lights flashing, then go off and  some lights go back on slowly, that means the device has been reset successfully.
 
Note: After hard reset please check the label at the back of the unit to get the default access info and login credentials.
Get to know more details of each function and configuration please go to Download Center to download the manual of your product.

 

Is this faq useful?

Your feedback helps improve this site.

From United States?

Get products, events and services for your region.