SmartThings Multipurpose Sensor
Smart Home
Aktualisiert 07-07-2017 06:04:09 AM
43071
43071 Dieser Artikel gilt für:
How to add the sensor to the Deco network?
- Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Sensors -> Multipurpose Sensor (Samsung SmartThings) -> NEW DEVICE.
- Tap NEXT, the app will say Searching…
- Pull the REMOVE WHEN CONNECTING tab on the sensor.
- Wait up to 60 seconds until the device is discovered. If not, tap SCAN AGAIN.
- When the device is discovered, tap NEXT and choose a location for it. Then tap DONE, and the device will list on the app.
How to reset the sensor?
- Press the push-tabs on either side of the Multipurpose Sensor to remove the cover.
- Hold down the Connect button (A) on the Multipurpose Sensor for 5 seconds.
- Release the button when the LED light (B) starts blinking red.
- If the sensor has already reset, the LED will immediately begin to double blink blue, indicating that the sensor is attempting to connect.
Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.
Troubleshooting
Fail to add the sensor / the sensor is offline/unreachable
- Move the sensor closer to the Deco router.
- Avoid physical obstructions and radio interference in the surrounding area.
- Reset the sensor and re-add it to the Deco network.
Finden Sie diese FAQ hilfreich?
Mit Ihrer Rückmeldung tragen Sie dazu bei, dass wir unsere Webpräsenz verbessern.
Von United States?
Erhalten Sie Produkte, Events und Leistungen speziell für Ihre Region