Gunilamp Smart Luminaire

Smart Home
Updated 07-07-2017 05:51:12 AM 33862
This Article Applies to: 

How to add a Gunilamp Smart Luminaire to the Deco network?

  • Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Lights -> Smart Luminaire (Gunilamp) -> NEW DEVICE.
  • Power on the bulb and wait until the light starts flashing in blue.
  • Tap NEXT, the app will say Searching…
  • Wait up to 30 seconds until the bulb is discovered. If not, tap SCAN AGAIN.
  • When the bulb is discovered, tap NEXT and choose a location for the bulb. Then tap DONE, and the bulb will list on the app.

 

How to reset a Gunilamp Smart Luminaire?

Switch on/off button five times until the light starts flashing in blue.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

 

Troubleshooting

Fail to add the bulb / the bulb is offline/unreachable

  • Make sure the bulb is already factory reset before you add.
  • Make sure the bulb is powered on.
  • Move the bulb closer to the Deco unit.
  • Unplug and re-plug the bulb, then try again.
  • Avoid physical obstructions and radio interference in the surrounding area.
  • Reset the bulb and re-add it to the Deco network.

If the problem persists, please contact our technical support team.

Is this faq useful?

Your feedback helps improve this site.

From United States?

Get products, events and services for your region.